суббота, 1 октября 2011 г.

remove carpet::Though a lot of people prefer to hire professional help, you can save a lot of money by just doing the job yourself remove carpet

remove carpet

remove carpet

remove carpet

remove carpet::Though a lot of people prefer to hire professional help, you can save a lot of money by just doing the job yourself.
When removing carpet from hardwood floors, it is first important to find out how it is attached there in the first place.
The steps you will take and the tools you will need will depend on the answer to that question.
When carpet is attached to hardwood floors by adhesive, you must first find out what type of adhesive was used.
If it is a dark brown or a tan adhesive, then it is probably tar based and mineral spirits can be used.
If it is a yellowlooking substance, then it is likely a general carpet adhesive.
This can be lightly scraped and chipped off easily.
After which, an allpurpose adhesive remover may be used.
Please take note that adhesive removers are solvent based, and therefore are very flammable.
Turn off all possible sources of sparks or open flames, including pilot lights and cigarettes.
Also, make sure that the room is properly ventilated, as the fumes can cause serious health repercussions due to their toxicity.
If tacks or nails are the attaching agents when removing carpet from hardwood floors, the tools you will need are work gloves, utility knife, needle nose pliers, hammer, pry bar, safety glasses, and a broom.
The first step is to remove a section of the carpet in the corner of the room will pliers.
Release the carpet from the tack strips and start cutting them into sections that you can easily remove.
Remember to be careful while cutting, else you might accidentally damage the hardwood under the carpet.
Needle nose pliers work best to remove these tacks.
Instead of aggressively yanking the tacks, you should patiently twist them sideways until they come off.
If your house is an older one, the previous owners might have used nails to eliminate squeaks from the hardwood, and keep carpet in place.
If this is the case, use the hammer with as little force as possible.
During all of this, be sure to wear the safety glasses.
Just be careful with yourself and the floor, and the results will come out smoothly.
remove carpet::Though a lot of people prefer to hire professional help,
you can save a lot of money by just doing the job yourself remove carpet

Комментариев нет:

Отправить комментарий